The week's pick
Reseach Article
Integrated monitoring of Encoder status parameters and GUI based Remote Control Panel using LabVIEW
| International Journal of Computer Applications |
| Foundation of Computer Science (FCS), NY, USA |
| Volume 43 - Number 3 |
| Year of Publication: 2012 |
| Authors: Amiya Ranjan Panda, Utpal Mandal, Hare Krishna Ratha |
10.5120/6083-8227
|
Amiya Ranjan Panda, Utpal Mandal, Hare Krishna Ratha . Integrated monitoring of Encoder status parameters and GUI based Remote Control Panel using LabVIEW. International Journal of Computer Applications. 43, 3 ( April 2012), 21-26. DOI=10.5120/6083-8227
Abstract
This paper describes the necessity of "Integrated Monitoring of Encoder status parameters and GUI based Remote Control Panel using LabVIEW" application, which is the implementation of serial and Ethernet data transmission using LabVIEW. Remote Control Panel (RCP) is an electronic instrument from which specified commands can be given to Encoders. The RCP is generally connected to the command Encoders through serial links (RS 232, RS 422). After getting the commands from RCP, the commands are generated at Encoders and are transmitted followed by different processing. In the hardware based RCP system, some faults are observed at RCP and the facility to monitor the Encoders status parameters at RCP is not present. To overcome these bottlenecks, a Personal Computer (PC) based integrated RCP system was visualized and developed based on LabVIEW. LabVIEW was used for better GUI interface and reduction of development time. This system takes Encoder status parameters from Encoder change over unit through Ethernet link and is serially connected to the Encoders to gives commands to it. Hence all the status parameters of Encoders are monitored as well as appropriate commands can be given to the Encoders through this application.
References
- LabVIEW 2009 by National Instruments, http://www. ni. com.
- LabVIEW Graphical Programming by Gary W johnsion (TMH).
- Zhou Hongfu; Xiao Xinyan; Tang Yong, "Serial Communication Interface Design Based on Lab VIEW and VC Mix Programming", 8th International Conference on Electronic Measurement & Instruments, (ICEMI2007) PP44-49, (in English) (ISTP/EI, INSPEC).
- Machacek J. ; Drapela J, "CONTROL OF SERIAL PORT (RS-232) COMMUNICATION IN Lab VIEW", 9th International Conference Modern Technique and Technologies, (MTT 2008) PP36-40.
- Sun Jian; Lu Peng; Fu Yaqiong; Liu Ruixiang; Chen Le, "The Implementation and Application of Programming Port Communication between Industry PC and Mitsubishi FX Series PLC", 3rd International Conference Intelligent System and Knowledge Engineering-2008 (ISKE 2008), Volume: 1, PP 1324 – 1327.
- Biao Lai; Huiqin Jia, "Design and implementation of Square-Cabin Environmental Parameters Monitoring System based on the virtual instrument", International Conference on Electronic and Mechanical Engineering and Information Technology (EMEIT-2011), Volume: 3, PP 1304 – 1307.
- Svinov, A. ; Turygin, Y. V. ; Sitar, J, "Remote control system and its development for linear asynchronous motor", MECHATRONIKA, 2010, 13th International Symposium, PP 105 – 108.
- Joan Marler and Frank Nezrick, 877,"Interferometer Digital Feedback and Control System", Fermi National Accelerator Laboratory, 1998, Internal Note 877-23.
Index Terms
Keywords